The Perma-Column® difference begins with simple installation processes that match your existing construction methods. There’s no need for special tools or equipment. Perma-Column® precast concrete columns install the same as standard post-frame columns and build the same as post-frame construction.

If the installation instructions you need are not available below, contact us.

HOW TO INSTALL: Place concrete pads or equivalent in bottom of hole. Tilt Perma-Column® off skid-loader forks into post hole. Perma-Column® must be placed so that the top of the precast concrete is above finished grade no more than 12-inches and no less than 8-inches in accordance with IBC Section 2304.12.2.2.

Place a wood spacer between every row of columns to avoid concrete to concrete contact. (A) Do not stack columns more than four rows high on a pallet. (A) Keep columns covered during storage and shipping to preserve appearance. PCs* can be dump unloaded by banding securely to wood bundle. (B) *PERMA-COLUMN to be hereafter referred to as PC.

2021年4月6日 · Matt Gerber, licensed and certified distributor of Perma-Column, demonstrates how to properly install a permanent foundation for a post-frame building. Footing options are discussed, and then...

HOW TO INSTALL: Place concrete pads or equivalent in bottom of hole. Tilt Perma-Column® off skid-loader forks into post hole. Perma-Column® must be placed so that the top of the precast concrete is above finished grade no more than 12-inches and no less than 8-inches in accordance with IBC Section 2304.12.2.2.

INSTALLATION TIPS Round orSquare PERMACast®/PermaLite Columns Installation Instructions FRONT Installing neck molding to SquarePERMACast®/PermaLite Columns 5. Put assembly in place and plumb. Make sure load is centered over column shaft and evenly distributed around the bearing surface. 3. Slip base over top of column shaft and

Place Perma-Column® deck post onto footing pad. Backfill dirt in 12" lifts, tamp after each lift. IMPORTANT NOTE: Steel bracket and the concrete column must not be cut or modified in any way. Attach optional uplift anchors to bottom of Perma-Column® deck posts with 1⁄2" bolt, tighten firmly until component stops rotating.

Square RoughSawn PermaCast® Fiberglass Column Installation Instructions 1. Trim the top of the column to be square. Smooth the top with a rasp or sanding block. 2. Mark the location of the center of the column on the center of the underside of the beam and drop a plumb bob to the floor. Mark this point on the floor with an "X".

• Place a wood spacer between every row of columns to avoid concrete to concrete contact. (A) • Do not stack columns more than four rows high on a pallet. (A) • Keep columns covered during storage and shipping to preserve appearance. • PCs* can be dump unloaded by banding securely to wood bundle. (B) PERMA-COLUMN, INC.