Evo Timing marks-Howto set static timing. - Harley Davidson …
2010年2月25日 · I think on your '97 EVO, the two (2) "dots" are the 20* advance mark. Your instructions for static timing call for this in the timing hole. My electronic ignition module static timing called for TDC (vertical line).
static timing my 1991 evo soft tail. | Harley Davidson Forums
2021年8月4日 · For Evos, there's a test harness for the [stock] cam position sensor which is used for both the vehicle attitude sensor test and for static timing.
Evo Static Timing - ChopCult
2018年3月30日 · If the engine will not start or runs very rough, you can use the following static timing procedure. Remove spark plugs and turn engine until TDC mark appears in observation hole. Ground spark plugs with an alligator clip so you will not shock yourself.
Best way to time an evo 1340 - cvoharley.com
2025年1月14日 · I used a timing light (stock ignition?) with a "wiper" tube in the hole, cuts down on oil mist. THEN, I advanced it just short of pinging when I pull a load up the grade. Got the best results at about 4 degrees advanced.
Timing older Evo's - Harley Davidson Forums
2016年7月5日 · If you're absolutely unable to find the timing mark in the window, even after playing around with the sensor/breaker plate, you may have to get your bearings by static timing it first. Raise the rear wheel off the ground.
timing - Harley Davidson Forums
2012年12月22日 · It may be easiest to access the green or green/white wire (depending upon model/year) at the connector at the ignition module, not the connector from the sensor plate (between the ignition module and the sensor plate).
Setting Timing On An EVO - Harley Davidson Forums
2008年2月6日 · Here's a page that will tell and show how to set the timing on an EVO and what the timing marks look like too. Setting Ignition Timing on your Harley
Setting Ignition Timing on your Harley - Nightrider.com
Locate the proper timing marks for your engine. If the shop manual is not available, remove spark plugs, turn engine until front piston is at TDC on compression stroke and identify TDC mark on the flywheel.
Evo timing question - V-Twin Forum
2008年9月16日 · It seems that most mechanics around here set the static timing at 0 with the timing mark in the middle of the hole, then let the module do the rest of the job with some tinkering with the switches. That's an easy enough way to do this, but it doesn't seem to be the best, at least on my scoot.
Evo Timing - Harley Davidson Forums
2010年11月29日 · I had a perfect tune before the rebuild so i put the ignition module back in the same position and retarded ever so slightly. Got a few hundred miles on and wanted to be sure of the timing. Let me say that i have tried the clear plastic …
- 某些结果已被删除