How to thread the machine - Video Included - Brother USA
7. Thread the needle from front to back and pull out about 2 inches of thread . If the thread take-up is lowered, the upper thread cannot be wrapped around the thread take-up lever. Make sure you raise the thread take-up lever and the thread take up before you feed the upper thread. If you feed incorrectly, it will cause sewing problems.
How to thread the upper part of the machine - Video Included
Follow the instructions below to thread the upper thread: - Click here for video instructions. 1. Turn the machine off. 2. Raise the presser foot lever. 3. Raise the needle by turning the handwheel toward you, so that the mark on the wheel points up. - If the needle is not correctly raised, the sewing machine cannot be threaded. 4.
Threading the machine - Brother USA
- Then thread the upperlooper thread, lowerlooper thread, right needle thread and left needle thread 4. Raise the telescoping thread three to its highest position. - Make sure that the thread holders are in alignment above the spool pins. 5. Place the spool of thread on the pin. - When using sewing thread spools, the thread spool cap should be used
How to thread the machine - Brother USA
Follow these steps to thread the machine: 1. Turn on the sewing machine. 2. Raise the presser foot using the (1) Presser foot lever. - If the presser foot is not raised, the sewing machine cannot be threaded correctly. 3. Raise the needle by turning the hand wheel toward you (counterclockwise) so that the (1) mark on the wheel points up.
Thread the machine - Brother USA
4. Feed the upper thread through the thread guide to left rear on first according to the diagram. 5. Pull the thread down and around the upper tension control dial from the right to the left so the thread picks up the thread check spring. 6. While holding the thread as shown below, pull it between the tension discs. 7.
How to thread the machine - Video Included - Brother USA
- The thread can easily be passed behind the needle bar thread guide by holding the thread in your left hand, then feeding the thread with your right hand. 12. Turn off the sewing machine. - If your machine is equipped with a needle threader, go to Step 14. - If your machine does not have a needle threader, go to Step 13.
Adjust the thread tension - Video Included - Brother USA
The machine needle that should be used depends on the type of fabric sewn and the thread thickness. If a needle and thread combination that is suitable for the fabric is not being used, the thread tension will not adjust correctly resulting in wrinkles in the fabric or skipped stitches. If you need assistance, please Contact Brother Customer ...
Automatic needle threader does not work - Brother USA
- Use home sewing machine n eedle sizes 75/11 through 100/16. → A size 65/9 needle cannot be used. 3. The wrong needle type is being used. - Do not use a w ing needle or a twin needle. 4. The type of the thread being used is not suitable for the automatic needle threader. - Do not use thread with a thickness of 130/120 or thicker.
Machine will not pick up bobbin thread - Brother USA
- Make sure you are using the correct bobbin in the machine. 7. Dust any lint that may have accumulated under the needle plate or in the bobbin case. If you continue to experience this issue, your machine will require service. Please use the following link to locate a Brother Authorized Service Center: Brother Authorized Service Center Locator ...
How to set the machine to automatically cut the threads
Follow the instructions below to set your machine to automatically cut the threads at the end of a design. This is called "programmed thread cutting" If programmed thread cutting is set, automatic reverse/reinforcement stitching is also set. This setting is convenient if a stitch for sewing buttonholes or bar tacks is selected. 1.