I am facing following problems while installing the MacOS installer of MCU-PLUS-SDK. It says the .dmg file is damaged and it cannot be installed. Could you please check this.

This thread has been locked. If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this ...

But why does this document mention uniflash also can be used on PC side? This make the reader confused.

I set up the simulation for bidirectional current measurement as per datasheet, figure 7-6. However, the simulation does not work. It works fine, however, when only connecting one INA301. I used the ...

our soc application need to open "/dev/dma_heap/carveout_edgeai_shared-memories", but in the development board, there is just 'linux,cma' and 'system' node in /dev ...

Need to drive analog PAL video over 5 meters coaxial cable, therefore it looks like capacitive AC-coupling is required. The question is if the OPA692 can drive the 75R coax load via large serial ...

I use FDC2212, I try to measure two capacitance which are CU plane on a PCB. But capacitor interact each other. There is two shielding concept releated on datasheet. But I can not undestand How I use ...

Could you please be more specific about 1, 3, and 4? For 1, are you referring to the quiescent current and also what state (on or off)? For the junction temperature ...

It is possible to run code on a Tiva C Series device that causes the device to lose JTAG communication. The two most common causes are: Changing the system clock speed to something that the target ...

My customer is trying to place the DataFlash area outside of the region setting, is there a problem? They are using IAR, it seems like IAR only have two regions can be set, and it is already used in ...

To troubleshoot, I tried loading it from U-Boot. When using signed remote core firmware, the authentication verification passed successfully. However, when using ...

This thread has been locked. If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this ...