I am facing following problems while installing the MacOS installer of MCU-PLUS-SDK. It says the .dmg file is damaged and it cannot be installed. Could you please check this.

This thread has been locked. If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this ...

Unfortunately PCM1792 and PCM1795 do not support DSD 128fs at all because DSD core only supports 64fs. So far there are no actual equipment information we have which supports DSD 5.6MHz by using our ...

We are trying to program CDCE925PWR clock chip using CDCEL9XXPROGEVM but when we connect the programmer it gives an error in device manager "Windows cannot verify the ...

But why does this document mention uniflash also can be used on PC side? This make the reader confused.

I set up the simulation for bidirectional current measurement as per datasheet, figure 7-6. However, the simulation does not work. It works fine, however, when only connecting one INA301. I used the ...

our soc application need to open "/dev/dma_heap/carveout_edgeai_shared-memories", but in the development board, there is just 'linux,cma' and 'system' node in /dev ...

Need to drive analog PAL video over 5 meters coaxial cable, therefore it looks like capacitive AC-coupling is required. The question is if the OPA692 can drive the 75R coax load via large serial ...

I use FDC2212, I try to measure two capacitance which are CU plane on a PCB. But capacitor interact each other. There is two shielding concept releated on datasheet. But I can not undestand How I use ...

exactly same as here, but no way to complete the installation.I also tried to launch orLibraryDownload from the command line, just for test. Here is the result: then, nothing happens.

We are using AM6254 processor and planning to provide HDMI output via the 24-bit DPI 2.0 interface. We will be using the Analog Devices ADV7511 HDMI transmitter (Hardware design support files), which ...

I have two different model development boards design by MYIR. I have two based on a 6254 (4 procs) and two based on 6252 (two procs). (so 4 total) They are identical otherwise. I have built my own ...