If you are wanting to configure a peripheral register as a DMA source or destination address, you want to use the "Manual" or "Variable/Function Name" options. Please see the explanation on the thread ...

This thread has been locked. If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this ...

I am facing following problems while installing the MacOS installer of MCU-PLUS-SDK. It says the .dmg file is damaged and it cannot be installed. Could you please check this.

We are trying to program CDCE925PWR clock chip using CDCEL9XXPROGEVM but when we connect the programmer it gives an error in device manager "Windows cannot verify the ...

But why does this document mention uniflash also can be used on PC side? This make the reader confused.

our soc application need to open "/dev/dma_heap/carveout_edgeai_shared-memories", but in the development board, there is just 'linux,cma' and 'system' node in /dev ...

Texas Instruments (TI) Audio support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search audio IC content or ask ...

Texas Instruments (TI) Amplifiers support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search amplifier IC content or ask ...

i m a university student trying to use the "TMS320C2000' DEVELOPMENT TOOLS, with the "HVMTRPFCKIT" kit and a PMSM motor. following the steps as they are, whenever i ...

Thank you for your question. In general, LDO's will be lower efficiency versus buck converters. However, most switching converters will have higher output voltage ripple, and higher integrated noise.

Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask ...

After SYNC, there is a deterministic delay between OSC rising edge and RFout rising edge. It's t2. In repeater mode, if the rising edge of SysRefReq meet the setup/hold timing requirement of OSC, ...